Amps
[Top] [All Lists]

[AMPS] drive xmfr ratios

To: <amps@contesting.com>
Subject: [AMPS] drive xmfr ratios
From: nospam4me@juno.com (nospam4me@juno.com)
Date: Tue, 4 Jan 2000 19:23:03 -0800
:From: "Maurizio Panicara" <i4jmy@iol.it>
:Once I've seen a grid driven amplifier in which a ferrite broadband
:transformer 50/200 ohm was used, probably to develop a bigger 
:voltage across grid without increasing the driving power. The 200 
:ohm port, that one going to the grid, was also terminated in a 
:200 ohm non inductive resistor but its size wasn't sure good to 
:dissipate large power and was probably there to establish a load 
:impedance, and nothing else. 

My 4cx250 amplifier uses a 9:1 ratio (50/450) terminated into two 
parallel 1.5K resistors and the LC networks. No problems with 
stability and my 10 watt max exciter drives it to full input. 
Last number crunch gave >17dB gain. You can have a look at the 
partial circuit at http://sonic.ucdavis.edu  Amateur Radio Pages. 

I would shy away from this higher ratio when the size of the tube 
requires handles. The stability requirements become more 
important. Though I've never had any problems using 9:1, I use 
it only because of the limited drive from my 10 watt exciter.

cheers
skipp 

________________________________________________________________
YOU'RE PAYING TOO MUCH FOR THE INTERNET!
Juno now offers FREE Internet Access!
Try it today - there's no risk!  For your FREE software, visit:
http://dl.www.juno.com/get/tagj.

--
FAQ on WWW:               http://www.contesting.com/ampsfaq.html
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>
  • [AMPS] drive xmfr ratios, nospam4me@juno.com <=