Amps
[Top] [All Lists]

[AMPS] THE SWR FINAL EXAM!

To: <amps@contesting.com>
Subject: [AMPS] THE SWR FINAL EXAM!
From: jono@enteract.com (Jon Ogden)
Date: Mon, 11 Oct 1999 11:04:55 -0500
OK,

Now, for the FINAL exam on SWR:

Joe Ham has a brand new amplifier that he plans to use exclusively on 
14.225 MHz.  His antenna is a beam that does not have the best match at 
14.225 MHz.  Therefore, Joe being a careful guy, has decided to put a 50 
Ohm isolator at the output of his amplifier.  Joe's coax is 50 Ohms and 
for practical purposes we will assume his coax is lossless.  The length 
of the coax is random and unknown.  His SWR meter is also 50 Ohms and has 
zero line length.  The impedance in Ohms of Joe's antenna at 14.225 MHz 
is 69.5+j36 Ohms.  This is measured INSIDE his shack at the input to his 
coax.

Questions:

1.) If Joe puts his VSWR meter after his isolator what is the VSWR that 
he sees?

2.) What percentage of Joe's power is actually radiated by his antenna?

3.) If Joe moves his VSWR meter 1/16 wavelengths closer to the antenna 
what is the VSWR he measures?  What is the impedance that is read at this 
point?

4.) If Joe moves his VSWR meter an additional 1/8 wavelength closer to 
his load what is his VSWR?  What is the impedance measured at this point?

5.) If Joe moves yet anothr 1/4 wavelength closer to the antenna now what 
is his VSWR?  The impedance?

6.) If Joe moves his meter an additional 1/16 wavelength, will the SWR 
and impedance be the same as in question 1?

7.) If Joe continues to move close to his antenna, will his VSWR change?

8.) What is the capacitance or inductance of Joe's antenna at the 
69.5+j36 Ohm point?

9.) What is the capacitance or inductance of Joe's antenna if he adds an 
additional 1/16 wavelength of coax to what he starts with?

10.)  Assume Joe has added the additional length of coax in question 9.  
Now he want to match that point with a 1/4 wave transformer at 14.225 
MHz.  What does the impedance of the transformer line section need to be? 
 How long is this line in meters?

11.) With the setup given in question 10, what percentage of power is now 
radiated by Joe's antenna?

12.) What will Joe's VSWR meter now read after his isolator?  Does he 
need the isolator any more?

Well, that's it!  Good luck!  Are you up to the challenge?

73,

Jon
KE9NA


-------------------------------------
Jon Ogden
KE9NA

http://www.qsl.net/ke9na    <--- CHECK IT OUT!  It's been updated!!!!!


"A life lived in fear is a life half lived."


--
FAQ on WWW:               http://www.contesting.com/ampsfaq.html
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>