Amps
[Top] [All Lists]

[AMPS] Re: The Worldwide, No Holds Barred, SWR Quiz.

To: <amps@contesting.com>
Subject: [AMPS] Re: The Worldwide, No Holds Barred, SWR Quiz.
From: measures@vcnet.com (measures)
Date: Tue, 5 Oct 1999 21:50:52 -0700
>
>measures wrote:
>
>>?  I'm trying, I'm trying.  .  I thought I recalled reading that you 
>>supported the theory that the placement of the SWR meter would make no 
>>difference in the SWR reading.   I was wrong.  Sorry, Jon.  
>
>Only, if the transmission line was 50 Ohms and the load was of a different 
>impedance (ie: a 100 Ohm load on a 50 Ohm transmission line measured with 
>a 50 Ohm instrument). 
>
>A half wave transmission line with a load at end A, repeats the impedance 
>of that load at point B (end of the line).
>
OK

>For your specific case, you are correct.  So one cannot always say that 
>placing an SWR meter at different points in a line will not change the 
>SWR.  But if the characteristic impedance of the line and the SWR meter is 
>the same, it will always read the same SWR.
>
?  With this I do not agree.   Only when there are no reflected waves 
does the SWR meter read the same everywhere on the line.  

>In your example, if we used a 93 Ohm SWR meter the SWR would measure 1.86 
>not matter where it was placed along that transmission line.
>

?  .  It seems to me that a 93-ohm SWR meter would read 1:1 at the center 
of the halfwave section and 1.55:1 at the ends  -- i.e., the 50-ohm 
points.

-  Rich..., 805.386.3734, www.vcnet.com/measures.  


--
FAQ on WWW:               http://www.contesting.com/ampsfaq.html
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>