>
>Others have written:
>
>>>the rf safety choke is there for a definite safety reason---to blow from
>the
>>>dc supply gitting thru the plate blocking cap--check it--bet it shorted.
>>>new call w5set.
>>
>
>And then Rich added:
>
>
>>When the DC blocker fails without a "safety choke" being present, the
>>Load C itself acts as a protective spark gap, arcs, and shorts the HV to
>>ground.
>
>
>My question: How long would it take a 10 ohm 10 watt high voltage safety
>"fuse" that is in the B+ line to open in the event the plate bypass cap did
>short and the load C saw the full anode potential?
? Hopefully never. The glitch R is not a safety fuse. There should be
no circumstance where a glitch R opens. Ideally, the glitch R limits
peak current until the primary fuse/circuit breaker opens. If a glitch R
sustains damage during a glitch, using a more formidable glitch R is
indicated. // The main reason to put a choke across the output is to
bleed off DC charge on the feedline.
- cheers, Lane
>
>Just curious. Wonder how dangerous this is to the operator other than the
>gun shot loud POP that happens when the resistors open scaring the hell out
>of the unsuspecting ham (in this case Ku7i).
>
>Lane
>Ku7i
>
>
>
>
>--
>FAQ on WWW: http://www.contesting.com/ampsfaq.html
>Submissions: amps@contesting.com
>Administrative requests: amps-REQUEST@contesting.com
>Problems: owner-amps@contesting.com
>Search: http://www.contesting.com/km9p/search.htm
>
-
- Rich...
R. Measures, 805-386-3734, AG6K, www.vcnet.com/measures
--
FAQ on WWW: http://www.contesting.com/ampsfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|