I bet this is how the kids on 14178 does it.
de SM2EKM
------------------------------------------------------------------------
------------
-----Ursprungligt meddelande-----
Från: amps@txrx.demon.co.uk [SMTP:amps@txrx.demon.co.uk]
Skickat: den 14 juli 1999 08:33
Till: amps@contesting.com
Ämne: VB: Re: [AMPS] Re: bias question
-----Original Message-----
From: Jan.E.Holm@telia.se <Jan.E.Holm@telia.se>
To: amps@contesting.com <amps@contesting.com>
To: <amps@contesting.com>
Date: 13 July 1999 09:57
Subject: [AMPS] Re: bias question
Fellows,
thank´s a lot for the input on my question. I
understand this
much better now. Sure wasn´t as simple as I thought but
what is these days. I did find the G3SEK bias circuit
on
the WEB so will use that one.
But then again using a class C driver to drive the big
amp
might prevent people from operating within 2 kHz from
my
frequency, hmmm just wounder ..........
73, Jim SM2EKM
----------------------------------
That will give you a very wide signal and complaints can be
justified. Much better is to put in an AM filter instead of
SSB after the rf processing, then make the amplifiers as
linear as you can; the signal is then clean after +/- 6kHz
or so. More subtle is to add noise through an AM filter, so
there is high noise around your signal to +/- 4kHz, then low
noise wideband.
Steve
FAQ on WWW:
http://www.contesting.com/ampfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search:
http://www.contesting.com/km9p/search.htm
--
FAQ on WWW: http://www.contesting.com/ampfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
<<Fil: Re_ [AMPS] Re_ bias question.TXT>>
--
FAQ on WWW: http://www.contesting.com/ampfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|