The AL811 was designed and sold in the United States. In the United States
amateurs are allowed only 250 watts on 10.1 MHz. You should check the
power allowed in your country.....
73
Jim W7RY
-----Original Message-----
From: Theo Koning <pb7cw@qsl.net>
To: amps@contesting.com <amps@contesting.com>
To: <amps@contesting.com>
Date: Friday, June 04, 1999 7:38 AM
Subject: [AMPS] questions about Ameritron AL-811H
>
>Hello and thanks for reading this,
>
>I have bought an Ameritron al-811hxce.
>It works fine, but only the 10.1 mhz gives a small problem , I can`t get
>enough power out of the tubes, it seems that the load is on the end of his
>range.
>The maximum output on that frequency is 350 watt, do you know why?
>On the backside of the amplifier are wholes with bandmarks on it, are these
>wholes to perform and peak the output on a specific frequency Band?
>
>I have also an other question, can I use this amplifier in full break-in
>mode in CW or do I need the
>optional kit?
>
>With best regards, Theo Koning
> =================================================
>Theo Koning PB7CW (ex PA3ERL)
>
> Internet E-Mail: pb7cw@qsl.net
>Homepage PB7CW: http://www.qsl.net/pb7cw/index.html
>
> Member Radio Club Kennemerland PI4RCK
>Homepage PI4RCK: http://www.qsl.net/pi4rck/index.html
>Homepage PI4COM: http://www.muurkrant.com/pi4com/pi4com.html
> ==================================================
>
>
>
>
>
>
>--
>FAQ on WWW: http://www.contesting.com/ampfaq.html
>Submissions: amps@contesting.com
>Administrative requests: amps-REQUEST@contesting.com
>Problems: owner-amps@contesting.com
>Search: http://www.contesting.com/km9p/search.htm
>
>
--
FAQ on WWW: http://www.contesting.com/ampfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|