I just aquired a Kenwood TL-922. Before placing it in service I will
add some circuit refinements such as step start and other changes as
described by others.
One item that I cannot find information for is detail about protecting
the filament transformer against meltdown although I recall that there
was discussion of this subject on this reflector some time ago. Can
anyone provide information about this modification? Thanks.
--
Court
You may communicate with me by using any of the following alternatives:
E-Mail: ve3az@passport.ca
FAX: 905-294-8756
Telephone: 905-294-8527
Canada Post: C.S.Broad
32 Wootten Way N.
Markham ON
L3P 3L9
CANADA
--
FAQ on WWW: http://www.contesting.com/ampfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|