Jon wrote
>Hi Dick,
>
>There is a trick that some of us talked about a few months
ago when I had
>the same problem with a 4-1K at high voltages on 10M.
>
>The tube does have a 7.6pf output capacitance. However,
put that puppy
>in socket and add a cabinet around it and your capacitance
probably
>doubles or tripples. Then you have the problem of matching
a large
>impedance with a somewhat large tune capacitance. The
answer is a
>super-high Q output tank. I calculated some possibilities
with my amp to
>be Qs of around 40 or so! Too much circulating current!
>
>The trick I used and used successfully, was to add an
additional coil on
>the output of the tube before the tune capacitor. This
coil is in series
>with the anode output line. Really you can put it between
your blocking
>cap and tune C. You'll need to experiment with different
coil values,
>but suffice to say, it will be fairly small. Just a few
turns is all
>you'll need.
>
>What this coil does is to act as an impedance step down
transformer. You
>can work out the math using series to parallel conversion,
etc. but it
>does work. Then you'll be able to use your pi-net to match
a lower
>impedance to 50 Ohms which is easier to realize.
You might also consider ditching the Pi matching system and
resonating the tube with a parallel inductor. Adjust the
loading with a variable position coupling loop.
Steve
--
FAQ on WWW: http://www.contesting.com/ampfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|