Amps
[Top] [All Lists]

[AMPS] Henry 2K2; glitch resistor in negative HV considerations

To: <amps@contesting.com>
Subject: [AMPS] Henry 2K2; glitch resistor in negative HV considerations
From: w4eto@rainbow.rmii.com (Richard W. Ehrhorn)
Date: Mon, 17 May 1999 13:35:48 -0600
No argument, Norm, although if I remember right the '5404 is rated for 400A 
surge for a longer time than a typical HV filter cap takes to discharge 
through a 20-50 ohm suppression resistor (~100A peak, decreasing on an RC 
decay curve of roughly 1 ms time constant (50 ohms x 20 uF, etc.).

73,  Dick

-----Original Message-----
From:   notawc@juno.com [SMTP:notawc@juno.com]
Sent:   Thursday, May 13, 1999 2:59 PM
To:     amps@contesting.com
Subject:        Re: [AMPS] Henry 2K2; glitch resistor in negative HV 
considerations




On Wed, 12 May 1999 08:45:37 -0600 "Richard W. Ehrhorn"
<w4eto@rainbow.rmii.com> writes:

SNIP


> With grounded-grid triodes we almost always apply positive bias to
> the
> cathode(s). A cheap, husky 1N5404 or similar diode, connected with
> its
> cathode to the cathode end of the resistor and its anode to ground,
> does
> the job of routing fault current to ground (and protecting cathodes
> & bias
> supplies) quite nicely.


IMO you want a diode that can handle the discharge current thru the
resistor and still survive.
Look at the Ameritron big amps and they all use a wimpy 1N4000 series
which goes up in smoke at the first opportunity.

A 1N54xx series is going in the right direction but I would suggest the
next step up, a 6A10 may be a better choice.  Remember, we want to be
able to absorb a problem until the primary fuse/breaker or HV fuse
reacts, not have it blow something in the protection chain.

Cheers...Norm


___________________________________________________________________
You don't need to buy Internet access to use free Internet e-mail.
Get completely free e-mail from Juno at http://www.juno.com/getjuno.html
or call Juno at (800) 654-JUNO [654-5866]

--
FAQ on WWW:               http://www.contesting.com/ampfaq.html
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


--
FAQ on WWW:               http://www.contesting.com/ampfaq.html
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>