On Sun, 21 Feb 1999 13:30:30 -0500 "Kenneth D. Grimm, K4XL"
<grimm@lynchburg.net> writes:
>The primary purpose of a bleeder in the power supply for my typical
>amateur amplifier is *not* for voltage regulation but to allow the
>voltage to bleed off of the filter capacitor. A good rule of thumb is
>100 ohms per volt, ie. for a 4500 volt supply, the bleeder would be
>450k
Excellent suggestion Ken but I would consider that up to about a 2KV
supply. A 200K total bleeder takes less time to discharge and there are
those of us who are impatient!
>ohms or thereabouts. Using ohms law, the current through the bleeder
>would be 4500/450000 = 0.01 amps. The power rating of the resistor
>would then be 4500 x 0.01 = 45 watts. Since safety is the primary
>concern with the bleeder, I would be inclined to use a power rating of
>100 watts or more. From a practical standpoint I would be inclined to
>use 5 series connected 100k 25w resistors.
However, the only truly
>safe
>bleeder is a big shorting bar on the end of a very long non-conductive
>stick, with ear-plugs inserted in your lug-holes, just in case...
>73,
>--
>Ken K4XL
I still have my "Mil-Sec" shorting bar. However due to the common
metering schemes and a B- rail raised above ground with a diode, damage
can result with a dead short discharge. Back to back 1N54nn series diodes
can usually protect the metering and should be a first step upgrade in
most commercial ham amps.
I prefer a shorting bar with a series 10K 10W resistor and use it when
the voltage gets down to 1KV or so. ( which is why I prefer lower value
bleeder R.) Then a direct short jumper lead while I have my fingers in
the hardware. Just remember to remove the jumper before firing up !
Above all, safety first.
73 Carl KM1H
>grimm@lynchburg.net
>BoatAnchor Manual Archive - http://bama.sbc.edu or
>ftp://bama.sbc.edu/boatanchor
>
>--
>FAQ on WWW: http://www.contesting.com/ampfaq.html
>Submissions: amps@contesting.com
>Administrative requests: amps-REQUEST@contesting.com
>Problems: owner-amps@contesting.com
>Search: http://www.contesting.com/km9p/search.htm
>
>
___________________________________________________________________
You don't need to buy Internet access to use free Internet e-mail.
Get completely free e-mail from Juno at http://www.juno.com/getjuno.html
or call Juno at (800) 654-JUNO [654-5866]
--
FAQ on WWW: http://www.contesting.com/ampfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|