Hi All,
I recently installed the Harbach SS-400 soft-start module
in my L4B and would be interested in hearing from others
who have done the same. Looks like my tubes may not be
fully cutoff as I am seeing a bit of plate current and a small
amount of neg grid current in standby - works fine otherwise.
My 120 volt line reads 100.3 in SSB with the module in and
125 with it out. No one else that I know of has experienced
this.
--
73, Dave - W3NP
Ft. Ashby, WV
--
FAQ on WWW: http://www.contesting.com/ampfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|