In message <36674ffe.139790@DOUGHALL>, Doug Hall <kf4kl@ipass.net>
writes
>Another question. I have access to a vector impedance meter. I know
>what the plate impedance will be for the tubes I've chosen. Can I
>terminate the tank output with 50 ohms and use the vector Z meter to
>select and verify the taps on the tank coil? It's an easy thing to do,
>but in practice will it result in the correct tap selections?
Should do - Often the accuracy on Z meters goes out a bit at 1000's ohms
so it's also worth doing it the other way round - replace the tubes with
equivalent R/C combinations and look for 50 ohms looking into the
antenna socket.
Steve
--
FAQ on WWW: http://www.contesting.com/ampfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|