Following the comments on tuned choke inputs, I agree with Bob and Rich: I
use tuned choke inputs on my linear with great success. But you do need a
suitably large cap for tuning - there is a fair amount of circulating
current. I have some 0.1mFd, 1 KV paper jobs about 50 years old and abt 6
inches high by 4 wide by 2 deep with big insulators. I figure that size is a
good indication of heat dissipating capability, while the measured tan delta
is pretty low. If you use negative lead filtering, you can rectify the
voltage across the choke for a low current bias source, while reducing the
insulation requirements on the choke.
I guess that resonant choke inputs are not used in the 'professional'
amateur amplifier for cost reasons - a string of electrolytics is much
cheaper. However, you can get much better regulation with a tuned choke, and
lower peak currents in the rectifiers and HV xfmr.
73 Peter G3RZP
--
FAQ on WWW: http://www.contesting.com/ampfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|