>I've building an amp which will use a pair UCSL750 caps in the tank
>circuit. I don't have any mounting hardware for these babies; what can
>be homebrewed at a resonable cost? Does the hardware need to be copper,
>and/or silver plated?
>
>thanks - Kevin N6ER
Jennings makes a silver plated clamp-on flange for mounting. Jennings'
recommended mounting position is vertical -- which puts less lateral
stress on the soft copper concentric plates. To do this, one needs a
right angle drive to bring the drive shaft out the front. Multronics
makes a right-angle drive that is Ideal for this application. The
Multronics right-angle drive is designed to replace the collet on the
Jennings screw-drive shaft. Be sure to set the cap. for maximum C (full
CCW) before replacing the collet with the right-angle drive.
Rich---
R. L. Measures, 805-386-3734, AG6K
--
FAQ on WWW: http://www.contesting.com/ampfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|