>...I only acquired my first amp about a week ago...a
>previously loved AL80A (single 3-500Z), so please bear with me if these are
>dumb questions.
>
>I, too, was wondering about Jeff, K4JNY's question about whether or not to
>leave the amp running. After reading Rich's referenced January 1994 QST
>article, "The Nearly Perfect Amplifier" I'm not sure if I know the answer
>although I think the step-start circuit would be kinder to the tube
>elements.
The primary issue is loss of emission. Operating the filament/cathode at
more voltage than is necessary to achieve normal output results in a
E2/E1^23.44 decrease in useful life of the tube. For a healthy 3-500Z,
4.8v on the filament is about right. I know of several models of 3-500Z
amplifiers which use c. 5.8v on the filament. The result is 1/84 - or
1.2% - of the potential useful life.
>
>However, towards the end of Rich's article, another issue arose which has
>been perplexing me:
>
>Do you need to connect the ALC line between the amplifier and the
>transceiver?
Not necessarily. The trade-off with ALC is leading edge splatter on
SSB, which is perfectly acceptable according to FCC rules.
>
>The vendor of my used amp said he never used it...he just made sure he was
>within the ALC on his transceiver. Others have told me that they would
>never use an amp without the ALC connection.
With a delicate oxide-type cathode, ALC reduces the chance of stripping
the cathode coating due to over drive. However, the tungsten-carbide
emissive coating on a thoriated-tungsten filament can not be stripped.
>...snip...
Rich---
R. L. Measures, 805-386-3734, AG6K
--
FAQ on WWW: http://www.contesting.com/ampfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|