3830
[Top] [All Lists]

[3830] CWopsT K9ZO Single Op HP

To: 3830@contesting.com
Subject: [3830] CWopsT K9ZO Single Op HP
From: webform@b4h.net
Reply-to: K9ZO@arrl.net
Date: Wed, 30 Nov 2022 16:40:13 +0000
List-post: <mailto:3830@contesting.com>
                    CWops Test (CWT) - 1300Z Nov 30

Call: K9ZO
Operator(s): K9ZO
Station: K9ZO

Class: Single Op HP
QTH: IL
Operating Time (hrs): 1

Summary:
 Band  QSOs
------------
  160:     
   80:   40
   40:  109
   20:     
   15:     
   10:     
------------
Total:  149  Mults = 129  Total Score = 19,221

Club: Metro DX Club

Comments:

80 was OK at the beginning, but I could tell activity was spread out to other
bands.  After 15 minutes everyone on 80 migrated to 40 even though there was
coverage over the entire USA.  Not big run.  Lots of activity on 40 when I went
there and had a good run, but in the past I had the SAL30 to quickly pick out
the weaker guys. It is down due to a wind storm, but the parts have been
repaired, just need the help to put it up again.  The main thing I would was to
not use the tent triangles to tighten the rope.  As the antenna vibrates, they
get loose.  Knots will be fine.  I would like to rebuild it with aluminum
tubing, but probably don't have the sizes since most of my tubing is from
tapered tubing as in Hygain elements.  I still get killed on 40 even though the
inverted vee is high.  The SteppIR 18e is on the ground and ready to go up,
perhaps this weekend. Ultimately I will have the 18e, very low dipole, inverted
vee, and 4 square for 40.  That should help.  However, not having an
omnidirectional antenna on 80 is a hindrance, so I will eventually use an
inverted vee and 4 square until I get a 4 square controller with an omni
position.  20 needs the 3 element sidemounted to the SE.


Posted using 3830 Score Submittal Forms at: http://www.3830scores.com/
______________________________________________
3830 mailing list
3830@contesting.com
http://lists.contesting.com/mailman/listinfo/3830

<Prev in Thread] Current Thread [Next in Thread>