Yaesu and related Items For Sale:
HF Linear Amplifier, VX-7 Accessories, several
Microphones, Communications Speakers, HT accessories,
Low Pass TVI Filters, Yaesu Original Manuals, and more
Amp Supply LK-500 Z A, HF Amplifier:
The LK-500 is an HF amp that runs a pair of 3-500 tubes, on
the 160 thru 10 meter bands, producing close to the legal
limit. On this amp, 30 watts of drive produces about 400
watts out of the amp; 50 watts gives about 650 Watts out;
etc.
This amp has a MUCH heavier duty Peter Dahl power transformer,
and covers 160 meters. It has a excellent tuned input matching
circuit. It is a superior amplifier.
This particular amp works very well. It has a manual step
start circuit added, and the electrolytic capacitors have
been replaced. Cosmetically it looks very, very nice. I
can not find a scratch on it. It looks like new.
Since this is heavy, I would much prefer pickup in the
Ocala, FL area.
With paper work for $900.
TenTec 715 RF Speech Processor:
The Model 715 RF Speech Processor is a high performance
true RF-type speech processor designed to operate with
most modern HF Amateur Radio transceivers. RF speech
processing is a superior system to traditional AF
systems found in a typical HF transceiver.
..Increase average SSB power output by up to 6 dB
..Enhance readability by stations hearing your signal
..Break pileups for DXpeditions faster
..Keep your net or contest run frequency clearer
..Easy to install, easy to operate
The 715 RF speech processor is installed between the
microphone and the microphone jack on your transceiver.
Two microphone inputs are provided -- an 8 pin microphone
connector wired for TenTec and Yaesu, and a 1/8” input
used for direct connection of microphones. 13 V DC required.
This particular unit works 100% and looks like new.
Paper work is included for $200.
Yaesu VX-7 accessories:
VX-7 Nifty Mini Manual
A pocket reference to all of those commands that no one
remembers! For the VX-7. Spiral bound. $18
Programming cable
This cable has the threaded connector as used by the VX-7,
but it can also be used on the VX-6, 5, 3, etc. Uses USB port.
It works great with the free "Chirp" program. I have not
tried it with others. $18
Yaesu YD-148 Dual Impedance Desk Microphone:
The Yaesu YD-148 is a very nice "goose neck" type desk microphone.
It has both high and low impedances, which can be selected by a
switch. This means it can be used on some of the older rigs
requiring a high impedance mic, or with the more modern rigs
needing a low impedance mic.
This particular mic is in very nice condition. It works 100%.
With round 8 pin connector for $75.
Yaesu MH-15 DTMF Touch Tone Microphone:
The MH-15 c6 is a hand microphone that features a 16 digit
DTMF Touch Tone Pad on the back, along with a lock/unlock
switch. The top has up/down buttons. Of course the PTT
is on the side. This one has the round 6 pin connector.
It works fine and looks close to new. $40
Yaesu YM-17 hand microphone:
The YM-17 is a hand microphone with up/down switches on
the top corner. It has the round 6 pin connector.
This one works fine and looks really great. $30
Yaesu YM-31 hand microphone:
The Yaesu YM-31 is a hand mic with a round 6 pin
connector. Apparently it is either similar or the
same as the MH-25A6j (not the MH-25 with the 8 pin
connector). It is a 600 ohm impedance hand microphone,
and has a Monitor on-off switch on the back.
It looks very similar to the Yaesu MH-1.
This one works fine and looks extremely nice. $25
Communications Speakers:
Realistic 21-549 A
This one is about 4 inches square but only about 2 inches
deep. It is rated for 5 watts, has an 8 ohm impedance, and
is listed as a 300 to 3000 Hz frequency response, making it
ideal for communications. 3.5 mm (1/8 inch) mono plug. It
is black in color, looks great, and sounds great. $18
Vanco SPB-5
Appears to be the same at above, but with a Vanco label.
Also includes gimbal mount. $15
Vanco SPB-6
Similar to SPB-5 above, but is considered a noise
cancelling speaker. 10 Watt rating. Still in original
box, new. $18
Low Pass TVI Filters:
A low pass TVI filter is added to the transmitter to reduce
harmonic interference. All have SO-239 connectors, and are
50 ohm filters.
The first one works on 6 meters as well as HF:
Drake TV-5200-LP Low pass TVI filter
This is the filter that may also be used on the low end of six
meters, as well as HF. It is good for 1000 Watts "average" below
30MHz, and about 200 W up to 52 MHz. It is the newer version
of the TV-1000. $30
Bencher YA-1, high power, low pass TVI filter
If you need a heavy duty filter for the output of your amplifier,
this one is ideal. It will take full legal power plus, and has at
least 80 db signal attenuation at TV channel 2. This one works
great, and is in its original box.
Bencher currently sells these for about $90. Only $60.
Bencher YA-1
As above, not in original box. $45
B & W FL-10/1500
This filter cuts off just above 10 meters, and handles 1500
Watts. It is the latest model B&W filter.In very nice condition,
it looks close to new. $40
Johnson 250-20 Low Pass Filter
This is a 52 ohm cylindrical low pass filter with a cut
off frequency of 45 MHz and 75 db of attenuation.
It is rated to take 1000 Watts of AM, or 5000 Watts
PEP SSB. With mounting bracket. $30
Para Dynamics PDC 1089
This filter is rated at a full Kilowatt, up to 30 MHz.
5 x 6 x 2 inch black box, instead of the more familiar long
enclosure. It looks like new. $25
Yaesu HT Accessory Items:
Belt Clip for Yaesu FT-207, with hardware. $8
Wrist Strap for Yaesu FT-209, and others $4
Rubber Duck antennas for your HT:
All are for 2 meters, are in good condition,
and are $10 each, unless stated otherwise.
BNC - Original Alinco EA0024, about 4 inches long
BNC - Original from Kenwood TH-215, about 5 inches long
BNC - "Stubby" about 4 1/2 inches long
BNC Connector - Standard, about 7 inches long
Type F connector - 6.5 inches long
BNC Stubby for 440 MHz, 3 inches long
Not a Rubber Duck, but can be used on your HT:
Telescoping Antenna w/ BNC about 19 inches long
can be used as a quarter wave antenna on
2 m, or on 220, or 450 MHz if telescoped shorter.
$12
Original Yaesu Manuals:
These are the manuals only, are all originals,
and not copies. Most are in close to new condition.
MH-1B A2B speaker microphone, $2
FNB-9,10,11,12 Battery packs, $2
FT-227 R, 2 meter "Memorizer", $7
FT-720 R, 2 meter mobile, $8
FT-736 dual band multimode, $12
FT-990 HF transcveiver, $12
FT-1000 HF transceiver, $15
FTH-2005 HT, $5
FTS-8 tone squelch unit, $3
FTS-12 tone squelch unit, $3
YS-60 Wattmeter / SWR Bridge, $3
SP-101 P, Speaker / Phone patch, $6
SP-901 P, speaker / phone patch. $6
VX-1 dual band HT, $10
VX-5 dual band HT, $12
These are original operating manuals only,
in very nice condition.
I also have many other accessories available such as many
different types of microphones, HTs, HF, VHF and UHF rigs, HF
and VHF/UHF antennas, and many miscellaneous accessories.
Just too many to list here. Please e-mail your requests.
Prices do not include shipping from Florida.
Thanks.
73,
Ken, W8EK
Ken Simpson
E-mail to W8EK@FLHam.net or W8EK@arrl.net
Voice Phone (352) 732-8400
_______________________________________________
Yaesu mailing list
Yaesu@contesting.com
http://lists.contesting.com/mailman/listinfo/yaesu
|