Yaesu Items For Sale:
Dual Band Multimode transceiver, Desk Microphone,
Power Cord, VX-7 Accessories, several Microphones,
2 m HT, HT accessories, and more
Yaesu FT-736 R, Dual Band, Multimode Transceiver:
The Yaesu FT-736R all mode transceiver incorporates up to
four band modules covering the 50, 144, 220, 440 and
1200 MHz amateur bands. It is supplied with 2 meters and
440 at 25 watts output. This radio has conveniences such
as IF shift, IF notch, keypad entry, noise blanker, all
mode VOX and three-speed AGC. The memory system includes
100 general purpose memories, 10 full duplex cross-band
memories and 1 call channel, all of which store mode and
frequency.
Features:
All Mode
Keypad Entry
100 Memories
IF Notch
IF Shift
Dual Digital VFO's
Semi Break-in CW
All Mode VOX
Built-in Power Supply
10 Duplex Memories
This particular unit works 100% and looks like new. It
includes the optional tone unit for subaudible tone encode
and decode, and the 600 Hz CW filter. It is still in
its original box, with paper work for $775.
Yaesu MD-1 Desk Microphone:
The MD-1 desk mic is a deluxe, high quality desk mic. It
features an UP-DOWN tuning function (assuming a compatible
Yaesu model radio). Impedance may be selected at either
500 or 50,000 ohms. Round 8 pin connector. It can be used
with most any of the Yaesu (and also TenTec) rigs that use
the round 8 pin connector.
This particular mic is still in its original box. Not a
scratch on it. It has been removed from the box, and
verified that everything works 100%.
With paper work, in its original box for only $115.
Yaesu E-736 DC Power cord
The box says for the FT-736, but I am sure it will work
with others as well, as it is the standard 6 pin molex
connector used by many different rigs.
This one is new, still in its original box. $22
Yaesu NC-72 B
This is the wall charger that is used with the VX-5 series
HTs (VX-6, VX-7, etc.), and also the FT-817, and probably
others. It is also used to power the CD-15 desk chargers.
This one is in its original box, apparently unused. $15
Yaesu VX-7 accessories:
VX-7 Nifty Mini Manual
A pocket reference to all of those commands that no one
remembers! For the VX-7. Spiral bound. $18
Programming cable
This cable has the threaded connector as used by the VX-7,
but it can also be used on the VX-6, 5, 3, etc. Uses USB port.
It works great with the free "Chirp" program. I have not
tried it with others. $18
MFJ-284 HT Speaker Microphone:
This speaker mic has the 3.5 mm and 2.5 mm plugs on
it, as used by Icom, Alinco, Radio Shack, some Yaesu,
and many other HTs.
It works with the following:
YAESU 109, 209, 709, 23, 73, 33, 727 and other YAESU
radios which are pin compatible with the above rigs.
ICOM 2AT, 02AT, 3AT, 03AT, 4AT, 04AT, 12AT, u2A, u2AT,
u4AT and other ICOM radios which are pin compatible
with the above rigs.
ALINCO DJ-560 and other ALINCO radios which are pin c
ompatible with the DJ-560
RADIO SHACK - most
SANTEC ST-20
It works great, and looks like new.
With paper work for $15.
Yaesu FT-209, 2 meter HT:
The Yaesu FT-209R operates on 2 meters from 144-148
MHz with 2.5 watts. The controls are easy to use.
High/Low power and VOX on/off is selectable from
the top panel of the radio. 19 soft rubber, dual-
function keys provide flexible control. There is
an analog meter and digital LCD display, along
with 10 memories.
This particular radio is in need of repair, or it
can be used for parts. It is dead. It does nothing
when turned on. No display, no audio, nothing.
This is the HT only with no accessories for $10.
World Map:
The Radio Amateur's World Map by Yaesu
This wall map is approx 34 x 24 inches in size.
It includes the ham prefixes on the various countries.
It appears to never have been used. $8
Yaesu MH-15 DTMF Touch Tone Microphone:
The MH-15 c6 is a hand microphone that features a 16 digit
DTMF Touch Tone Pad on the back, along with a lock/unlock
switch. The top has up/down buttons. Of course the PTT
is on the side. This one has the round 6 pin connector.
It works fine and looks close to new. $40
Yaesu YM-17 hand microphone:
The YM-17 is a hand microphone with up/down switches on
the top corner. It has the round 6 pin connector.
This one works fine and looks really great. $30
Yaesu YM-31 hand microphone:
The Yaesu YM-31 is a hand mic with a round 6 pin
connector. Apparently it is either similar or the
same as the MH-25A6j (not the MH-25 with the 8 pin
connector). It is a 600 ohm impedance hand microphone,
and has a Monitor on-off switch on the back.
It looks very similar to the Yaesu MH-1.
This one works fine and looks extremely nice. $25
Yaesu HT Accessory Items:
Belt Clip for Yaesu FT-207, with hardware. $8
Wrist Strap for Yaesu FT-209, and others $4
Antennas for your HT:
All rubber ducks are for 2 meters, are in good
condition, and are $10 each, unless stated otherwise.
BNC - Original Alinco EA0024 - 4 inches long
BNC - Original from Kenwood TH-215, about 5 inches long
BNC "Stubby", about 4 1/2 inches long
BNC Connector, about 7 inches long
Type F connector - 6.5 inches long
BNC Stubby for 440 MHz, 3 inches long
Not a Rubber Duck, but can be used on your HT:
Telescoping Antenna w/ BNC about 19 inches long
can be used as a quarter wave antenna on
2 m, 220, or 450 MHz. $12
I also have many other accessories available such as many
different types of microphones, HTs, HF, VHF and UHF rigs, HF
and VHF/UHF antennas, and many miscellaneous accessories.
Just too many to list here. Please e-mail your requests.
Prices do not include shipping from Florida.
Thanks.
73,
Ken, W8EK
Ken Simpson
E-mail to W8EK@FLHam.net or W8EK@arrl.net
Voice Phone (352) 732-8400
_______________________________________________
Yaesu mailing list
Yaesu@contesting.com
http://lists.contesting.com/mailman/listinfo/yaesu
|