He does not sat what radio, my RX ANT is next to the power button on the
FT-1000
73 Will NA2NA
----- Original Message -----
From: "Mike Gilmer, N2MG" <n2mg@eham.net>
To: <yaesu@contesting.com>
Cc: <epetek1@att.net>
Sent: Thursday, December 01, 2005 9:05 PM
Subject: Re: [Yaesu] receive antenna
> Did you select the new antenna by pressing the RCV button (near the ANT
> A/B
> switch) on the front panel? Simply plugging in something to the rear
> panel
> jack does nothing wihtout pressing that switch - the radio will continue
> to
> use the TX antenna to receive.
>
> Mike N2MG
>
>> Never used the receive antenna jack until last week when I
>> attached my new beverage. I couldnt tell any difference . It
>> seemed as though the receiver was the same whether the
>> antenna was in or out. Is there something very simple I am
>> missing? Tnx fer any help- Pete W2LL
>
>
> _______________________________________________
> Yaesu mailing list
> Yaesu@contesting.com
> http://lists.contesting.com/mailman/listinfo/yaesu
>
_______________________________________________
Yaesu mailing list
Yaesu@contesting.com
http://lists.contesting.com/mailman/listinfo/yaesu
|