I just discovered a strange problem tonight. Even though the dial says
7.200, it isn't on that frequency. If I transfer VFO A with this frequency
to VFO B and listen with DUAL enabled, I receive the correct frequency on
VFO B.
Putting both VFO's on the same frequency, I can hear stations on VFO A that
are not on the VFO B. When I transmit on 7.200, I'm transmitting, but who
knows where. I get no MONI feedback at all until I move somewhat below
7.200 and somewhat above about 7.280.
Has anyone else here using a FT1000D ever seen this problem?
73, Dave - W5UN w5un@wt.net
homepage: http://web.wt.net/~w5un Grid: EM23mg
RR 10, Box 27
Mount Pleasant, TX 75455
_______________________________________________
Yaesu mailing list
Yaesu@contesting.com
http://lists.contesting.com/mailman/listinfo/yaesu
|