Hi Folks,
I have an extra CAT RS232 inferface cable (32023008) by W1GEE if anyone
is interested. $25 shipped to you door.
73s,
dave
wa3gin
Phil wrote:
>HI All, I wonder if the CAT interface of my FT1000 works good via the MAX232
>homebrew project taken from the 2001 ARRL handbook ?
>I have mounted it and:
>a) the cat signal glows from time to time for some seconds then disappears (
>no intermittent blinkings as on the MP)
>b) no tuning via the shift key within the N6TR logging program, just changes
>the xmit frequency (split mode) with some delay.
>b2) no band change
>c) baud rate seems to work on 4800. Other slower rates no! The com port is ok
>, tried it with a 1000MP.
>d) the tuning knob seems to be blocked when the CAT signal lights on, but the
>RX is active.
>e) powering it off the rig is again operative.
>I have also tried to change the pinout either pc side and rig side. Only one
>setup seems to respond with the max232 interface.
>Do you have any suggestion.
>Thanks es 73 de Phil IC8POF
>
>
>_______________________________________________
>Yaesu mailing list
>Yaesu@contesting.com
>http://lists.contesting.com/mailman/listinfo/yaesu
>
>
>
#################################################################
#################################################################
#################################################################
#####
#####
#####
#################################################################
#################################################################
#################################################################
|