I use an FT-1000mp with an AL-1200 and have not encountered this problem.
I thought something like that was going on one time, until I remembered how I
had set the ALC in the amplifier. Adjusting or disconnecting ALC have any
effect?
Seems ALC is almost unnecessary for this combination since it would be difficult
to overdrive the AL-1200 with an FT-1000mp, but I operate CW and RTTY.
I am interested in other comments, if any. ke7gh@primenet.com
----------
From: Lynn D. Osterbur[SMTP:no9z@prairienet.org]
Sent: Thursday, December 19, 1996 5:54 PM
To: yaesu@contesting.com
Subject: [Yaesu] swr kickback on MP
I have a FT1000MP which dosent like to put out full power into my AL1200
amp. Some bands, some frequencies it runs 100 watts into the amp. Any one
with similar experience? The amp appears to have a 1.4 to 1 swr maximum.
So, I am guessing that the rig is being held back by an oversensitive
swr kickback circuit. Any ideas or solutions? 73 Merry Xmas. Lynn
--
FAQ on WWW: http://www.contesting.com/yaesufaq.html
Submissions: yaesu@contesting.com
Administrative requests: yaesu-REQUEST@contesting.com
Problems: ke7gh@contesting.com
Sponsored by: Akorn Access, Inc & KM9P
--
FAQ on WWW: http://www.contesting.com/yaesufaq.html
Submissions: yaesu@contesting.com
Administrative requests: yaesu-REQUEST@contesting.com
Problems: ke7gh@contesting.com
Sponsored by: Akorn Access, Inc & KM9P
|