So do I understand correctly that if N3RS calls me and I type in his
callsign, it doesn't send his callsign and then give the exchange? I have
to use Function keys to achieve this?
Mark KB3Z
On Mon, Apr 6, 2026 at 3:13 PM Ken Widelitz <kwidelitz@gmail.com> wrote:
> Hi Mark,
>
> Writelog doesn't have an S&P mode. You just hit the memory with your
> callsign and when they come back to you you hit the memory with the
> exchange.
>
> 73, Ken, K6LA / VY2TT
>
> On Mon, Apr 6, 2026 at 12:00 PM Mark Griffin <pastormg2@gmail.com> wrote:
>
>> Normally with N1MM you can designate whether you wish to run or use S&P.
>> Of
>> course when running you normally hit the enter key and your transceiver
>> calls CQ. When someone responds to your CQ you enter their callsign and
>> hit
>> enter and your transceiver sends the exchange. Once that is done they give
>> you their exchange and you hit enter and your transceiver sends TU and
>> QRZ.
>> And then the process of calling CQ starts all over again. I see that there
>> are S&P memories, but don't see anything specific with regards to running.
>> Can anyone assist me with this?
>> Mark Griffin, KB3Z
>> _______________________________________________
>> WriteLog mailing list
>> WriteLog@contesting.com
>> http://lists.contesting.com/mailman/listinfo/writelog
>> WriteLog on the web: http://www.writelog.com/
>>
>
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|