In order to have CW in SSB (MK II CW works during SSB), "CW in Voice"
must be checked in Router's PTT tab (for transceivers that support it),
and the transceiver must be in "break-in" (CW VOX must be enabled).
CW in voice prevents MK II from generating PTT with keying when it
detects the rig is in phone.
Note from the Yaesu instruction manual - transceivers (FT-2000 and
later) must have the "A1A CW Auto" menu item set to ON to permit CW
in SSB.
73,
... Joe, W4TV
On 12/14/2013 12:24 PM, Courtney Judd wrote:
Joe Subich, W4TV wrote:
yes, i have looked everywhere but no luck! Cort
Is "CW in Voice" checked on the PTT tab in Router?
73,
... Joe, W4TV
On 12/14/2013 9:48 AM, Courtney Judd wrote:
using ft2000d with micro keyer2 ver 8.40... so while trying to change
the tail on the CW keying, something changed that I can no longer key
the radio with the paddle while in SSB or short the key to tune. What
did i mess up now, any ideas? tnx Cort K4WI
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|