> Cable is a 9 pin serial cable with pins 2,3, and 5 connected
> straight thru.
By default, the FT-2000 requires RTS/CTS handshake. You will
need a cable with 2,3,5,7 & 8 or you will need to disable
handshake in the FT-2000 menu (check your manual) and disable
RTS support in Writelog.
73,
... Joe, W4TV
> -----Original Message-----
> From: writelog-bounces@contesting.com
> [mailto:writelog-bounces@contesting.com] On Behalf Of Aldewey@aol.com
> Sent: Sunday, December 13, 2009 11:00 PM
> To: writelog@contesting.com
> Subject: [WriteLog] CAT Problems with FT2000D
>
>
> This may not be a Writelog problem but I thought I would
> start here. I
> received a brand new FT2000D this week and just can't seem to
> get the CAT
> control to work with Writelog. I've used it with the my
> previous FT1000D and
> FT1000 Mark V with no problem.
>
> There is my setup:
>
> Com Port is set to 4800, n, 8, 2
>
> In Writelog, Port selection is set for FT2000, 4800, poll
> checked, Com PTT
> = YES
>
> Cable is a 9 pin serial cable with pins 2,3, and 5 connected
> straight thru.
> This same cable worked fine on my FT1000 Mark V.
>
> In the FT2000D, Menu Setting 28 is set to 4800, Menu setting
> 29 set to 100,
> Menu Setting 30 is set to On(but I have tried off here also).
> Menu Setting
> 31 is set to On.
>
> A note with the FT2000D says it includes the latest PEP 2000 Software.
>
> Serial Number is 7M270409
>
> Any ideas what I may be missing?
>
> 73,
>
> Al, K0AD
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|