>From looking at the Radio Compatibility Cart on the West Mountain Radio web
site I see that the ICOM IC-765 in NOT supported. Oh well so much for hoping
something will work with the IC-765.
N8RF
-----Original Message-----
From: writelog-bounces@contesting.com
[mailto:writelog-bounces@contesting.com] On Behalf Of Don Melcher
Sent: Thursday, October 29, 2009 9:42 PM
To: writelog@contesting.com
Subject: [WriteLog] Simple & compact USB>Radio Control/CW/DVK/RTTY interface
I started looking for a simple, compact one radio USB>Control/CW/DVK/RTTY
interface to use with my Icom or Yaesu radios for portable use and I found
one. Thought I would share with the group.
West Mountain Radio Rigblaster Plug & Play fit my needs. USB & Audio I/O to
the computer. Control, CW, Audio and PTT to the rig. Works with all CI-V
Icom radios and most Yeasu with the apprpriate adapters. They say it does
not work for control with Kenwood but I am going to check that out with my
TS850 as I don't know why it doesn't work with some of the older radios that
are TTL. List for about $110.
For DVK, you plug the mic into the computer instead of the audio out of the
interface and it works FB. The radio audio I/O is via the ACC connector on
the back (Data on Yaesu). I have tested it with my Icom 703, 706IIG & 746 -
it should work with all Icom. Haven't had a chance to test it with my FT817
- the only Yaesu I have besides a FT1000D - and that radio is FAR from
portable. ;)
Don
W6CZ/NM6G
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|