A quick look in the Writelog help file, under Writelog.ini > PORTS,
you'd find this:
There are 4 "slots" available for WriteLog rig interfacing. By
default, CommSlot1 is COM1:, but you can change that by changing the
number on the right of the equal sign. These settings are not used for
RTTY or for packet
CommSlot1=1
CommSlot2=2
In this example, the third and fourth slots are on COM7 and COM8.
COM15 is as high as is supported.
CommSlot3=7
CommSlot4=8
73, Chad WE9V
On Mon, Jul 28, 2008 at 12:14 PM, Eric Hilding <b38@hilding.com> wrote:
> Tnx to all for the overwhelming direct and reflector responses to my
> previous posted question.
>
>
>
> Today is the ultimate $64,000 question to sew up getting my new
> solar/battery remote site dilemma resolved to be able to use WriteLog in the
> CW NAQP this weekend.
>
>
>
> The WL Port Setup dialog window only allows for COM 1,2,3 & 4.
>
>
>
> In order to use WL and have it share the RS-232 connection to my remote
> TS-480 (rig body) with W4MQ's IRT program, I have to use a Virtual COM Port
> (the one VCOM assigned is COM 11).
>
>
>
> I seem to recall there being some way in the WriteLog .ini file to make COM
> 1 in the WL Port Setup actually go to COM 11 inside the Confuzer, but maybe
> I was dreaming? If it can be done, I will be the Happiest Camper on the
> planet today. Coincidentally, the rig at the remote site is located inside
> a small 6 PACK camper I took off the pickup. Go figure.
>
>
>
> TNX in advance for any assistance.
>
>
>
> 73.
>
>
>
> Rick, K6VVA * The Locust
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
>
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|