It appears to work just fine if you set the radio to FTDX-9000.
Just got done doing a few basic checks here with Writelog,
microHAM microKEYER and FT-2000. WriteLog was configured as
always for operation with the microKEYER, the only change was
to specify FTDX-9000 as the radio in Setup | Ports.
Writelog could read frequency and mode from the radio, the radio
would QSY properly in response to clicking on the bandmap.
73,
... Joe, W4TV
> -----Original Message-----
> From: writelog-bounces@contesting.com
> [mailto:writelog-bounces@contesting.com] On Behalf Of KR4DA
> Sent: Saturday, October 28, 2006 10:27 PM
> To: writelog@contesting.com
> Subject: Re: [WriteLog] Rig Interfacing FT2000
>
>
>
> I played in the CQWW SSB test this week end...
> First time using writelog.
> I wonder if anyone used a FT-2000 with writelog and how are
> you doing it.
> Would of been really nice to control the radio via writelog.
>
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|