I am setting up Writelog on a new Windows 2000 computer. The box already
has two standard COM ports installed as COM1 and COM2. I installed my
Byterunner 4 port Serial I/O PCI card. The install seemed to go OK but the
new ports
show up as COM5, COM6, COM7, COM8 in Device Manager.
When I go to the Setup Ports in WL, all I see , of course, is COM1 Thru
COM4. I can't seem to establish communications on the Byterunner Card. I
tried
using ports 3 and 4 thinking that maybe they map to COM5 and COM6 some way
but no luck. In Device Manager, I tried setting the BIOS COM Port Number to
COM3 or COM4 but that didn't seem to help either.
Any suggestions? I didn't seem to have this problem on my Windows 98 box.
73,
Al, K0AD
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|