Is there a setting that controls how long the rig stays keyed after a CW
message? I'm trying out a new microHam CW keyer and when WL is used to do
keying, after the CW message it appears to remain keyed for about 1/2
second.
When WL is not running, the microHam Router control seems to be in effect.
Even if I have the MH router "enable host override" checked, it doesn't
seem to make a difference. WL just seems to keep things keyed up longer
than I'd like. I do have the keyup delay set to 100ms to give the amp
relays a change to key. Setting that to 0 keys faster, but makes no
differce on unkey.
Thanks for any ideas,
Kelly - N0VD
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|