gbaron@home.com writes:
<< At 12:30 11/12/2001, DieselCar@aol.com wrote:
>k7jj@arrl.net writes:
>
><<
> When CQ'ing (Run), I select the calling station with the mouse and the
call
>populates the Callsign field. However, the cursor jumps to the RST field. If
>I hit Enter at this point I expect the call and rst to be sent. Instead the
>qsl/qrz message is sent.
>. . . .>>
>
>Dave,
>
>Try the following:
>1 - on WriteLog main window, click ENTRY
>2 - click ENTRY SENDS EXCH/QRZ
<<
This is true , BUT the cursor jumps out of the Call field when you use the
mouse to select and enter the call,NOT GOOD, and now you have to use the
exchange key, not enter. It should wait for a space bar before it leaves
the call field as it does with a manual entry.
This is something that should be fixed as soon as possible. It is not
logical to work this way.
>>
Gil,
By using the INSERT key, the last hi-lited call will be captured, placed in
the CALL ENTRY filed and sends the exchange. This is one way that one is
assured that the cursor stays in the CALL field until one moves it.
Rick W4UEF
>When ENTER is hit wid the cursor is in the CALL window, it will send the
>exchange. That is, I have my exchange on F10. When the cursor is in any
field
>other than CALL then F3 (%r%d TU GL QRZ? de W4UEF TEST%r%e) is sent. Since
my
>exchange is on said keys then the following is in WRITELOG.INI:
>[Configuration]
>
>SendCallExchangeKey=10
>QrzFunctionKey=3
>
>Gud luck
> ue Rick W4UEF
|