I have an 850 and I built the interface that is shown in the Writelog help
file. Following the instructions there, I have had great success using
Writelog for PSK, RTTY, SSB, full rig control. I have comm1 for rig control
and comm2 to the RTTY RCA jack on the back of the 850. I have my own
homebrew CW interface that runs off of my LPT port and works just fine with
Writelog.
The help file has everything you need to hook up Writelog with an 850.
Jim VE9WH / VE9TTY
http://ve9wh.weblink.nbtel.net/dxclusters.html
DX Cluster Telnet sites
-----Original Message-----
From: writelog-admin@contesting.com
[mailto:writelog-admin@contesting.com]On Behalf Of RSAUVAN
Sent: Thursday, October 11, 2001 11:23 AM
To: writelog@contesting.com
Subject: [WriteLog] rtty tx
I have been unsuccessful in getting my Kam to work at all
on rtty with WL.So, I have gone to the sound card to try
and get it working. I am able to receive data on the stereo afsk
setting. I have wired a cable for the 850 kenwood as follows.
Mic jack on rig-pin 1 (mic) to center pin on plug to sound card.
pin 7(mic gnd) to outside shield of plug to computer
When I go into transmit (alt k) the buffer window comes up,then if I
hit alt k again the transmit window comes up and keys the rig for a brief
moment. I do not hear a carrier though when it keys up.Also as all of
this is happening, I lose my rtty window.I am getting quite frustrated
with this as I have been trying to get this going for nearly a week.I
bought WL mainly for rtty. Last night I replaced the sound card that
was in the computer with another one.I dumped the whole computer
and loaded win 98 since I was using win 95 before, hoping this would
help possibly.Still the same problem. Any input from anyone would be
grateful.
Thanks-Bob-WT9Q
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
|