I bought a full set of bolts and nuts to replace the old non-Rohn bolts that
have been connecting my 60' 45 for the last 30 years. Lots of surface rust
so it is time to replace.
I notice that the nuts have three 'dings' at the edge of the threads,
obviously to provide a 'locking' function of a sort. It will require
wrenching to get them snugged up to the tower leg.
Does it matter how the nut is installed: dings in or dings out? I can't
think of a reason why, but ought to ask before I start the changeout.
Thanks for this groups expert advice!
Al
N6TA
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|