I used a 2 part foam many years ago on a 30 ft 10 meter Yagi boom. It made the
boom quite rigid and strong. The materials I used were industrial marine grade
so they would not absorb water. I’ve seen similar products on Amazon
https://www.amazon.com/TotalBoat-Urethane-Density-Flotation-Reinforcement/dp/B01AAWRYZG/ref=mp_s_a_1_1?ie=UTF8&qid=1524769730&sr=1-1&pi=AC_SX236_SY340_QL65&keywords=two+part+foam&dpPl=1&dpID=51TCGebM86L&ref=plSrch
Or you can just search 2 part foam marine to see the various products
available. I can say that the particular product I used held up very well. But
it was so long ago I have no idea what manufacturer I used.
Bob KT3RR
Sent from my iPhone
> On Apr 26, 2018, at 11:42, Charles Gallo <charlie@thegallos.com> wrote:
>
>> On Thu, April 26, 2018 9:20 am, Bob Shohet, KQ2M wrote:
>> I would also expect that the rate and quality of the “curing” would be
>> impacted by the ambient temperatures and humidity levels/climate at a
>> given location. In much of New England the temperature can easily vary
>> by more than 120 degrees in the course of a year – and significantly more
>> in the great plains states. And the climate can very enormously from the
>> generally wet/humid East to the desert SW. This has to have an impact.
>>
>> 73
>>
>>
>> Bob KQ2M
>
> Of course there are foams (2 part) that mix on spray, and don't require
> water vapor to cure
>
> That said, what is the problem you are trying to solve? Usually foams are
> used to stop vibration/change resonance frequency. Here is the question
> (and I don't know the answer) - how often do we see fatigue
> cracking/failure on the BOOM of an antenna? Not the elements - heck, they
> crack on some, but I don't think I've heard of booms failing except during
> extreme events like ice/wind storms.
>
> The foam might not give you ANY extra strength, and even you look at
> strength/weight, I'm going to guess it'll be a net negative. Now if you
> know your boom has a vibration problem, we are talking another story.
> Even then, there are probably better ways to make the boom stiffer (put an
> end cap on both ends, attach a cable that runs inside the boom from end
> cap to end cap, and come up with a way to tension the cable - aka put the
> boom under compression, or put a metal ROD in, and put the boom under
> tension - both will change resonance)
>
> The material that interests me. I've heard that they make tube that is
> similar to ACM sheet - basically a pair of Al tubes, with a composite in
> between (ACM siding is polystyrene or similar)
>
> I'm wondering if these materials might be the way to go in new designs -
> they are about 90% as strong, but also less than half the weight. I
> wonder if we could go to some of the carbon fiber/aluminum composite
> tubes, and get MORE strength, for LESS weight (for the same size), or
> downsize, to go SAME strength, but less area and load.. (of course at
> greater expense)
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|