All of the boxes I have seen are OEM Hub City, Series W300 I believe. They
are not too hard to rebuild if you are so inclined. Replacements were
about $400 last time I priced one. Your gear box should have the model
number stamped into a machined pad somewhere on the housing.
http://www.hubcityinc.com/
Hope this info is of use & good luck on your project.
73
Matt
KM5VI
-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of
shorton
Sent: Thursday, May 11, 2017 1:31 PM
To: towertalk@contesting.com
Subject: [TowerTalk] Replacement worm gear box for TX-472 motorized tower...
Hi to the group...I was wondering if anyone had a source other than US Tower
where to buy the dual shaft worm gear drive on TX-472 motorized tower with
positive pull down...Mine is showing signs of dragging I think...Had a hard
time trying to lower and raise back up yesterday...Motor and started cap.
tested fine...Called US Tower and almost keeled over on there price for
replacement gear box...Samuel
--
KD4ESV EL87RL06SB BRADENTON,FLORIDA
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
____________________________________________________________
Actress Maggie Q Shocks With Her Solution To Tummy Troubles activatedyou.com
http://thirdpartyoffers.juno.com/TGL3131/5914adcce3b6e2dcc7193st02duc
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
---
This email has been checked for viruses by AVG.
http://www.avg.com
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|