Hang a pulley over a limb and secure it. Run the antenna support line
through the pulley. No more abrasion.
Les W2LK
On 2/15/2017 7:22 PM, NC3Z Gary wrote:
I have been using what I thought was high quality UV resistant Dacron to
support my inverted L's. But the problem is as it runs through the
support pine trees it comes into contact with several limbs and branches
and it has been abraded to the point of failure in about 6 months. This
has happened a couple of times.
Any good products out there that is more resistant to limb abrasion?
Gary Mitchelson
NC3Z/4 Pamlico County, NC FM15
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|