Hi Howard,
Yes, Bury-Flex ™ will well outlast LMR-400 UF. Times uses a TPR (thermoplastic
elastomer) outer jacket to enhance flexibility. TPR is not great for lasting in
UV more than 6-8 years. When I designed Bury-Flex ™, I used a med. density PE
outer jacket which is highly resistant to UV, certain chem's, and totally
waterproof at outdoor temps/ambient pressure to fairly high pressure. I also
used 19 strand to enhance flexibility vs. 400 UF which is a 7 strand (less
flex).
Bury-Flex ™ is a very popular cable for not only hams but also NASA uses it
(ground station), Lockheed Martin, FAA, etc. The "smoothness" of the outer
jacket reduces friction thus excellent for coil around crank up towers. The
cable can be buried without conduit, run thru water, ponds, salt water (have
at least one ham who feeds his 4 el vert phased array which is in salt water
inlet.
RF Industries which you mention: an excellent quality source of commercial
grade connectors. We are an authorized distributor for them for over 20 years,
never a problem. The RFU-507SI (silver body, silver pin, teflon dielectric)
are excellent , thus you have chosen the right one for this cable.
The die that you use is same as for LMR-400, 9913, Bury-Flex: .128 and .429,
which you have.
If you need strip dimensions, RFI has that in their catalog, and on their web
site but if any problem, I can send those to you with the "Stripping Key"
diagram (search that name on their web site and I think (?) you can find it
there too.
Good DX, 73, Steve K1PEK
DAVIS RF Co, Div. of Orion Wire Co., Inc.
DavisRF.com
Affiliates: Davis/Orion Marine Cable
Davis Rope and Cable Assembly (DavisRopeAndCable.com)
> Message: 2
> Date: Mon, 15 Dec 2014 08:41:26 -0800
> From: Howard W6HDG <W6HDG@arrl.net>
> To: towertalk@contesting.com
> Subject: [TowerTalk] Ultraflex coax questions
> Message-ID:
> <20141215164127.MRSZ11247.fed1rmfepo203.cox.net@fed1rmimpo110>
> Content-Type: text/plain; charset="us-ascii"; format=flowed
>
> Hi all. I am about to order about 110 feet of coax for a new
> MA770MDP tower/ Steppir DB18 install. I'm thinking of using either
> genuine LMR400 Ultraflex or Davis Bury Flex coax.
>
> Davis BuryFlex is cheaper and I understand it has a tougher and more
> slippery jacket for crank up/down use? Opinions?
>
> I am going to try crimp-on RFU-507SI RF Industries PL-259's for the first
> time. For the center conductor crimp, I have alternatively
> heard of .118 and .128 crimpers being used. I have the dies for
> both .118 and .128 as well as the .429 braid crimp. Any opinions? Do you
> use any dielectric compound such as STUF inside the PL259 to inhibit
> corrosion?
>
> Tnx, Howard W6HDG
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|