I use a good old fashioned 6 pin trailer connector set, one on the rotator
tail and the other on the cable. All pins and holes well covered with
CorrisionBlock. And I live on the ocean, been up since 2003 and only finally
corroded inside this year (should have put some seal where the wires enter
the rubber block). Available at any auto parts store usually. Made for the
wx!!
Don W7WLL
-----Original Message-----
From: W3YY
Sent: Wednesday, August 20, 2014 4:27 PM
To: towertalk@contesting.com
Subject: [TowerTalk] Trailer Hitch Electrical Connectors for Rotator Cable
Does anyone have any recommendations for trailer hitch electrical connectors
that work well as rotator control cable connectors? I would like to have at
least 5 conductors in the connector, if possible.
73, Bob - W3YY
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|