the controllers for the g800,1000,2700, and 2800 sdx and dxa are all
interchangeable as far as I have seen with the exception of the plugs and one
little detail...
the 2700 and 2800 have an extra limit switch to do the automatic slowdown when
you get near the stops. that is the 6th wire that is used on them that isn't
used on the
800/1000 series. I have replaced all my control boxes with greenherons now.
May 13, 2014 01:02:37 AM, SawyerEd@Earthlink.net wrote:
Thanks Grant. This looks like a project looming for me may this winter. I
have a few of these rotor units and would love to get one good 2800 out of
them as a spare. I will let the group know how it turns out.
Ed N1UR
-----Original Message-----
From: Grant Saviers [mailto:grants2@pacbell.net]
Sent: Sunday, May 11, 2014 2:13 PM
To: Edward Sawyer; towertalk@contesting.com
Subject: Re: [TowerTalk] Yaesu Rotors
The basic control/indicate design is the same in all, as far as I can tell.
A 500 ohm pot inside the rotator and a servo in the controller that nulls an
inside pot to match (not sure the value). The schematics and pcb
implementation inside the controller is a witches brew mess, and the gear
train + o-ring belt drive a total PITA to replace the o-ring pointer "drive
belt".
Shortly I will connect a 2800SDX control to a G1000 rotator as the G1000SDX
controller is flakey. Then one more cross over will be tested. If not,
then both controllers get pitched for a Green Heron.
My G1000SDA control works fine with a G1000SDX rotator, but having had the
rotator apart I think all G1000 rotators are identical. Might also be true
for the 2800 series.
Motors, gears and bearing arrangements are different among the rotator
families AFAIK. Limit switches look to be stock micro-switch variants.
I replace the bizarre keyed Jones type receptacle on the 2800 series
controls with a stock Jones 300 6 pin from Mouser. $5.
Grant KZ1W
On 5/11/2014 9:22 AM, Edward Sawyer wrote:
> Dear Towertalkians:
>
>
>
> Repair Shop - Does anyone know if Yaesu Repair services the in tower
units?
> It seems that maybe they have stopped. They were the only ones that
> did before.
>
>
>
> Swappable Parts - What is the feeling of parts inside the housing as
> far as interchangability? Pots, limit switches, motors, etc between
> the 800, 1000, and 2800 series?
>
>
>
> Thanks for any info.
>
>
>
> 73
>
>
>
> Ed N1UR
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|