Towertalk
[Top] [All Lists]

Re: [TowerTalk] wireless rotor

To: towertalk@contesting.com
Subject: Re: [TowerTalk] wireless rotor
From: Les Kalmus <w2lk@bk-lk.com>
Reply-to: w2lk@bk-lk.com
Date: Wed, 10 Apr 2013 17:01:25 -0400
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
None that I can hear.

Les W2LK

On 4/10/2013 4:44 PM, Jack Brindle wrote:
Maybe.

Putting a major noise source (micro controller with lots of high-speed clocks) 
right at the single most important quiet area might not be that good of an 
idea. Adding chokes and bypass caps to knock down the noise can only go so far. 
I'd rather not have the noise generator at the antenna in any case.

Which brings up the question, what kind of birdies and noise does the Green 
Heron and similar devices add?

Jack B.

On Apr 10, 2013, at 7:06 AM, Jim Lux <jimlux@earthlink.net> wrote:

On 4/10/13 6:38 AM, Charles Lind wrote:
I've been using Green Heron Everywhere for three years to control a rotor
and switching for five antennas with no failures or downtime.  Saves a lots
of expensive cable, the groundhogs can't eat the wireless signal, and if
something were to go wrong, I wouldn't have to dig up 400 feet of cable.
Chuck, N8CL


this really is how hams should be heading.. with cheap wireless interfaces, 
Arduinos with 802.11 or Zigbee, etc.

There's a nice $50 relay board from Velleman (K8056) that has 8 SPST relays on 
it and can be controlled by RS232, TTL serial, discrete 8 bits, or a RF 
receiver module.  They also have 16 and 4 relay boards.
THere's probably a ton of things from SparkFun that stick right onto a Arduino.


There's even a new Ethernet Relay card from Velleman
http://www.velleman.eu/products/view/?id=407510
$150 on Amazon..  Pretty slick.

There's a Arduino with Ethernet built in and lots of example programs out there 
to do basic control stuff (or complex control stuff).

It won't be long before someone builds an open source rotator controller using 
an Arduino and H bridge or relay board. They're cheap, easy to learn to program 
(either in C using free tools, or in the sort of C-like Arduino IDE) and plenty 
smart enough to run a control loop for a rotator.

Get yourself a nice WiFi bridge (I like using the 5 GHz band so I don't have to 
fight all the 2.4 GHz stuff) and you're done.



And, hey, it uses *radio*... we can move beyond wired telegraphy to, gosh, 
wireless.

(I will happily buy a beverage of choice for the first person who controls 
their antenna with a spark gap transmitter and coherer, though.  Very 
steampunk..)

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk



_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>