Doug,
With as long of a run you have, I would highly suggest you put the motor cap
out by the rotor. This has two BIG advantanges; first it frees up the two
wires used for the cap, and you can put one in parallel with each of the motor
run wires. This has the same effect as using larger wire. Second, you
ellimiate any voltage drop in the long run back to the cap in the control box.
This will allow the cap to be more effective and the motor to produce more
torque.
I have five Tailtwisters/Ham IV's on towers at my QTH with runs of 250 to 300
ft; I used the above method, and have no trouble turning any of my big mono
banders.
Rather than removing the cap out of the control box, purchase a new one (or two
and have a spare) and mount it in a plastic box right by the rotator with a
foot or two of wire.
Additionally, over the time, the cap wears out and needs to be replaced. I
just replaced the one on my 15 meter antenna rotor; turning had become very
slugish (especially in the cold). I put the cap up there when I put up the
tower and antenna about 15 years ago. The new cap did the trick; due to other
issues and maintenance on my other towers, I had replaced the caps around the 8
to 10 year service on those towers.
Dick K8ZTT
>
>
> Date: Sat, 12 Jan 2013
> From: Doug N4IJ
> Subject: [TowerTalk] HamIV Rotor sluggish
>
> The rotor is on a tower and the run is about 275 ft from the shack.
> What is the best way to get more response from it? At times I have to
> rock the antenaa back and forth to get it to even move. I am sure it
> must be voltage loss. Boost the voltage from the controller?
> Doug, N4IJ
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|