I had this problem with an older Tristao. Lou Tristao told me to bend the
cross bar out a little. Rubbing did cause the wire to splinter which is a
real problem if not replaced finally.
73 Dave K4JRB
----- Original Message -----
From: "SPWoo" <jj_2_woo@yahoo.com>
To: <towertalk@contesting.com>
Sent: Thursday, October 18, 2012 12:49 PM
Subject: [TowerTalk] Crank up tower bracing rubbing against cable
Hi All,
I've discovered that my less than a year old TX-472 tower has three places
where the steel cable is rubbing against the tower. Attached below is a link
to some photos of the problem. In one spot the interference has worn away a
lot of metal and it caused some cable wear. I was wondering if anyone has
experienced this and what I could do to remedy it. I've sent the photos to
US Tower and I'm still waiting for their response. I crank my tower down
every day and sometimes under light wind condition. I don't know if wind has
anything to do with it. Thank you and very 73.
http://www.flickr.com/photos/26071865@N02/
Best Regards,
Jonathan Woo, W6GX
(970) 646-1711
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|