Don't mean to lead the topic astray, but were there any signs of cable wear
before the accident? Maybe the rest of us can prevent a future mess...
Chris
KF7P
----- Original Message -----
From: "Bill Erickson" <ericksonw@gmail.com>
To: <towertalk@contesting.com>
Sent: Tuesday, May 22, 2012 2:04 PM
Subject: [TowerTalk] Recabling info needed for US Tower HDX-589
>I have had the misfortune of a cable breaking on my US Tower HDX-589. The
> fall from 89 feet to 23 feet didn't hurt it, but the stop at the bottom
> was
> a killer! I am in the process of fabricating 5 new pulley brackets and
> replacing some of the 2 inch by 1 inch "U" channels that were bent or
> whose
> welds to the upright tubes were broken. No problem there. I have been
> unable to get any help whatsoever from US Tower. My cables were damaged in
> the fall/stop so I do not want to trust measurements on them to have new
> cables made. Does any one have the dimensions of the various cables, and a
> cable routing diagram for this tower? Any help would be greatly
> appreciated. I have already missed 2 "Must Have" DxPeditions. Thanks and
> 73, Bill N6MXU
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|