Pete,
Try this page too:
http://www.tessco.com/products/displayProducts.do?groupId=576&subgroupId=40
<http://www.tessco.com/products/displayProducts.do?groupId=576&subgroupId=40>
Go about 2/3 down the page.
73, Les W2LK
On 6/7/2011 7:45 AM, Pete Smith wrote:
> I bought a crimping tool at Dayton with two dies, but the openings in
> the dies are identified only by dimensions, not by the connector they
> are to be used on. I've tried Googling without success, but suspect
> there must be a table somewhere that I can use for reference - any ideas?
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|