Re: [TowerTalk] Which crimper die for which connector

[Les Kalmus <w2lk@bk-lk.com>]

Pete,

Look at Standard Die Sets on this page: 
http://www.rfparts.com/coax_accessories.html
Might help.

73,
Les W2LK

On 6/7/2011 7:45 AM, Pete Smith wrote:
> I bought a crimping tool at Dayton with two dies, but the openings in
> the dies are identified only by dimensions, not by the connector they
> are to be used on.  I've tried Googling without success, but suspect
> there must be a table somewhere that I can use for reference - any ideas?
>
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk