Here are just 3 sites from a simple Google search on "single point
grounding"
http://www.astrosurf.com/luxorion/qsl-lightning-protection3.htm
http://www.w8ji.com/ground_systems.htm
http://www.k1ttt.net/technote/onepoint.html
Non DC grounded antennas (those without a trifiler wound balun or system NOT
measuring 0 ohms with an ohm meter across the coax) should always have a
high impedance choke or resistor to discharge static! A Polyphaser will NOT
normally dissipate static unless it has a DC ground path inside.
73
Jim W7RY
--------------------------------------------------
From: "Bill Jackson" <k9rz@radiks.net>
Sent: Friday, December 31, 2010 12:48 PM
To: <towertalk@contesting.com>
Subject: [TowerTalk] Recommended Coaxial Surge Protector for HF
> Happy New Year!
>
> I have a question for the Group about the various brands of coaxial
> lightning
> protection.
>
> Without going into a lot of detail, I have a SPG copper buss bar in the
> basement that serves as my coax and control cable entrance panel. Each
> coax
> and control cable has an appropriate Polyphaser protector mounted to the
> panel.
> For my HF antennas, I currently have a Polyphaser IS-50UX-C0 protecting
> the
> single run of 1/2" Heliax out to the tower where I have a remote antenna
> switch
> installed.
>
> This morning during a heavy snow and sleet squall, I walked into the shack
> to
> the sound of "tick, tick, tick" coming from the Drake LP-1000 low pass
> filter
> connected to the coax line running to the SPG in the basement. As soon as
> I
> turned the antenna switch to the "off" position, which grounds the
> feedlines
> feeding the remote antenna switch on the tower, the "tick, tick, tick"
> noise
> stopped. This is the first time in the 15 years the antennas have been
> installed that I have ever heard a static discharge inside the shack.
>
> My first assumption is that the Polyphaser surge protector on the coax
> cable
> feeding the coax switch has lost it ability to shunt a high voltage
> build-up on
> the center conductor to ground. However, I have not seen any other
> symptoms
> such as high SWR indicating the protector may have gone bad. I do not
> have a
> schematic of the protector, but I assume there is some type of gas
> discharge
> device from the center conductor to ground? Short of having a Hi-Pot
> tester,
> is there any other way to verify the protector is still working as
> intended?
>
> Reading some of the reviews on eHam.net would suggest there have been
> quality
> control issues with Polyphaser since the company merged with Transtector.
> Has
> anyone performed any evaluation or testing of the various brands of
> coaxial
> surge protectors, such as ICE or Alpha Delta that would recommend a
> replacement
> for the Polyphaser? The current price of a IS-50UX-C0 is about $60. I do
> not
> want to spend good money on a protector that is questionable or is going
> to
> fail prematurely under QRO operating conditions.
>
> Thanks and 73
>
> de Bill, K9RZ
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
>
> -----
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 10.0.1191 / Virus Database: 1435/3350 - Release Date: 12/31/10
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|