I am putting back up a Cushcraft A3S tribander after it was on the ground
for several years. I've cleaned it and rebuilt it, triple checking the
dimensions. Installed at 45 feet, I get the following MFJ 269B readings for
best resonances: 10m - 26.6 MHz, SWR=1.8, R=38, X=33; 15m - 21.55 MHz,
SWR=4.3, R=8, X=21; 20m - 14.95 MHz, SWR=2.9, R=37, X=73.
These resonances are very sharp, and clearly not right. Any ideas on how to
test this? Is there a simple way to test each trap? While I didn't open up
each trap, I did soak them and thoroughly rinse them to try to clean any any
stuff that might have been inside.
Thanks and 73,
Rob, KA1ARB
--
Rob Katz, Director
Legacy Center, Inc.
(919) 678-6000 x106 (919) 678-6015 fax
www.TheLegacyCenter.com
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|