Thanks, Doug. I will set them both the same and for about 2 seconds and see
if that works. My tower is at our country place, which we visit on
week-ends so will check it out then. This problem follows my tilting the
tower to the ground to paint the four Steppir fiberglass tubes; now upright,
the motor does not start. So relays may not be the problem but last time the
tower would not crank up, replacing a relay was the remedy. We shall see.
And thanks for giving this tower dummy an idea of what the relays do. Hi.
Ed W1MAG
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|