I used one similar to this in my homebrew reversible beverage:
http://www.jameco.com/webapp/wcs/stores/servlet/Product_10001_10001_99311_-1
There are many more you can find like this for around the same price.
You need only a small signal relay. DX Engineering uses a similar relay
in their reversible beverage system.
Les W2LK
On 8/28/2010 11:48 AM, Drax Felton wrote:
>
>
> What would be a good 12-volt relay to use to select between two Beverage
> antennas at the input of the transformer (a DX Engineering DXE-BFS-1)
>
>
>
> I don't think I need an expensive RF relay since it's receive only. I was
> considering using one of these from Mouser:
>
> http://www.mouser.com/ProductDetail/Tyco-Electronics-PB/T92S7D22-12/?qs=sGAE
> piMZZMtSzCF3XBhmW2NPbS%252b1btPI3iw0%252bkgwM5c%3d
>
>
>
> Any thoughts?
>
>
>
> KB3X
>
>
>
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|