Same here. I never liked that wrench in the first place.
Bob-
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of k3mm@verizon.net
Sent: Saturday, July 03, 2010 10:21 PM
To: k4gmh@arrl.net
Cc: towertalk@contesting.com
Subject: Re: [TowerTalk] AB577 Clamp Wrench
Mike, we just use a screwdriver.
73, Ty K3MM
Jul 2, 2010 10:30:30 PM, k4gmh@arrl.net wrote:
>Need to replace the wrench used to secure and remove the clamps on an
>AB577. One of the wrench's prongs for engaging the clamp broke off during
>Field Day installation of the tower. Any ideas where to obtain another
>wrench or repair the broken one?
>
>--
> 73,
> Mike, K4GMH
>_______________________________________________
>
>
>
>_______________________________________________
>TowerTalk mailing list
>TowerTalk@contesting.com
>
>target="_blank">http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|